搭建一个小型的asterisk电话系统 (五、增加efax功能)

一、安装依赖包（libtiff & spandsp）

$ sudo apt-get install libtiff4 libtiff4-dev

$ mkdir ~/src/asterisk-complete/thirdparty
$ cd ~/src/asterisk-complete/thirdparty
$ wget http://www.soft-switch.org/downloads/spandsp/spandsp-0.0.6pre21.tgz
$ tar zxvf spandsp-0.0.6pre21.tgz
$ cd spandsp-0.0.6

$ sudo make install

二、把spandsp库放入libpath

$ sudo cat >> /etc/ld.so.conf.d/usrlocallib.conf
/usr/local/lib

通过$ sudo ldconfig使其生效

三、重新编译Asterisk添加spandsp支持

$ cd ~/src/asterisk-complete/asterisk/1.8/
$ ./configure
$ make menuselect

确保Resource Modules菜单下的res_fax_spandsp看起来像[*] res_fax_spandsp，保存并退出

$ make
$ make install

四、检查

重新启动asterisk,通过以下命令确认spandsp是否已经工作

*CLI> module show like res_fax_spandsp.so

Module Description Use Count
res_fax_spandsp.so Spandsp G.711 and T.38 FAX Technologies 0
1 modules loaded

如果看到如上结果，则表示spandsp可以工作了，也就是说SendFax() & ReceiveFax()可用在extensions拨号方案中了

五、配置拨号方案

收传真，

[fax-out]exten => s,1,Verbose(2,Set options and transmit fax); some folder where your outgoing faxes will be foundsame => n,Set(faxlocation=/tmp); In production you would probably not want to hardcode the filenamesame => n,Set(faxfile=faxfile.tif)same => n,Set(FAXOPT(headerinfo)=Fax from xxxx.org)same => n,Set(FAXOPT(localstationid=xxxxxx)same => n,SendFax(${faxlocation}/${faxfile})