Sun服务器Solaris10安装步骤 (三)
--------------------------------------------
Esc-2_Continue Esc-6_Help
提示是否需要使用DHCP来配置主机的IP地址； 在我们的安装中，不使用DHCP功能，因此按Esc-2键继续安装；
- Host Name for bge0 -----------------------
Enter the host name which identifies this system on the network. The name
must be unique within your domain; creating a duplicate host name will cause
problems on the network after you install Solaris.
A host name must have at least one character; it can contain letters,
digits, and minus signs (-).
Host name for bge0 N2000NGN2
--------------------------------------------
Esc-2_Continue Esc-6_Help
输入主机名，本例中，我们输入主机名N2000NGN2后按Esc-2键继续安装；
- IP Address for bge0 ----------------------
Enter the Internet Protocol (IP) address for this network interface. It
must be unique and follow your site's address conventions, or a
system/network failure could result.
IP addresses contain four sets of numbers separated by periods (for example
129.200.9.1).
IP address for bge0 12.3.102.23
--------------------------------------------
Esc-2_Continue Esc-6_Help
提示输入主机的IP地址，本例中，输入12.3.102.23后按Esc-2键继续安装；
- Subnet for bge0 --------------------------
On this screen you must specify whether this system is part of a subnet. If
you specify incorrectly, the system will have problems communicating on the
network after you reboot.
> To make a selection, use the arrow keys to highlight the option and
press Return to mark it [X].
System part of a subnet
-----------------------
[X] Yes
[ ] No
--------------------------------------------
Esc-2_Continue Esc-6_Help
提示主机的网络是否采用子网掩码的方法，本例中，要采用子网掩码的方法，因此按Esc-2键继续安装；
- Netmask for bge0 -------------------------
On this screen you must specify the netmask of your subnet. A default
netmask is shown; do not accept the default unless you are sure it is
correct for your subnet. A netmask must contain four sets of numbers
separated by periods (for example 255.255.255.0).
Netmask for bge0 255.255.255.0
--------------------------------------------
Esc-2_Continue Esc-6_Help
提示你输入主机的子网掩码，本例中，输入255.255.255.0后，按F2键继续安装；
- IPv6 for bge0 ----------------------------
Specify whether or not you want to enable IPv6, the next generation Internet
Protocol, on this network interface. Enabling IPv6 will have no effect if
this machine is not on a network that provides IPv6 service. IPv4 service
will not be affected if IPv6 is enabled.
> To make a selection, use the arrow keys to highlight the option and
press Return to mark it [X].
Enable IPv6 for bge0
--------------------
[ ] Yes
[X] No
--------------------------------------------
Esc-2_Continue Esc-6_Help
提示你是否采用IPv6技术？本例中，不采用IPv6技术，按F2键继续安装；