CCNA网络系列实验（1）之GNS3安装配置指南

㈠ 安装GNS3
如果安装过程有提示WINPACP已经安装过了，选择“取消”

㈡ 配置GNS3基本参数

选择 step1

一般：
配置两个地方

① 拓扑图存放路径
② 存放临时文件

Dynamips：

① 这个是IOS模拟的重要组件，必须关联上，在GNS3安装目录里有

② 临时文件的存放目录

③ 然后进行测试：

Capture：

存放抓包文件的临时目录

Qemu：

存放PIX临时文件

然后测试

选择 step2

这里我使用3640的IOS

IDLE PC的值默认是没有的，要计算后才有

接下来计算IDLE的值

R1>enR1#conf tEnter configuration commands, one per line.  End with CNTL/Z.R1(config)#int f0/0R1(config-if)#ip add 12.12.12.1 255.255.255.0R1(config-if)#no shR1(config-if)#endR1#

IDLE只要计算一次，以后就可以直接用

㈢ 测试：

R1>enR1#conf tEnter configuration commands, one per line.  End with CNTL/Z.R1(config)#int f0/0R1(config-if)#ip add 192.168.1.110 255.255.255.0R1(config-if)#no shR1(config-if)#endR1#*Mar  1 00:10:07.191: %SYS-5-CONFIG_I: Configured from console by consoleR1#*Mar  1 00:10:07.859: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up*Mar  1 00:10:08.859: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to upR1#ping 192.168.1.111Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 192.168.1.111, timeout is 2 seconds:!!!!!Success rate is 100 percent (5/5), round-trip min/avg/max = 16/65/124 msR2>enR2#conf tEnter configuration commands, one per line.  End with CNTL/Z.R2(config)#int f0/0R2(config-if)#ip add 192.168.1.111 255.255.255.0R2(config-if)#no shR2(config-if)#endR2#*Mar  1 00:10:48.759: %SYS-5-CONFIG_I: Configured from console by consoleR2#*Mar  1 00:10:48.979: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up*Mar  1 00:10:49.979: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to upR2#R2#ping 192.168.1.110Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 192.168.1.110, timeout is 2 seconds:.!!!!Success rate is 80 percent (4/5), round-trip min/avg/max = 20/53/88 ms